ATTA 50 Gallon Diesel Auxiliary Tank & Toolbox Combo Full Chest AT50CB
ATTA Products are shipped directly from the manufacturer. Current lead time is 4-5 weeks on all tanks.
The AT50CB, the 50 gallon aluminum auxiliary tank and FULL SIZE CHEST toolbox combination.
The AT50CB gives you the full size chest box option you are looking for. The aluminum toolbox is a single lid design with duel paddle latches and is bolted to the back of the 50 gallon auxiliary tank. The toolbox is 18" tall x 20" wide x 60" long. The 50 gallon tank is constructed from .125 gauge aluminum and is fully baffled to prevent fuel slosh. The AT50TT is designed to fit any Dodge, Ford, or GM full-size long bed diesel trucks. NOTE: WILL NOT FIT SHORT BED TRUCKS.
All of our fuel tanks and fuel systems meet or exceed all DOT, EPA, and VESC-22 regulations.
ATTA's Toolbox is constructed from .125 (1/8") gauge aluminum. Compare that to our competitor's toolbox with is made from .063 (1/16") gauge aluminum.
- CAPACITY: 50 Gallons
- MATERIAL: .125 gauge aluminum/ fully baffled
- DIMENSIONS: 18" tall x 30" wide x 60" long (Toolbox Dimensions 18" tall x 20" wide x 60" long)
- FILL NECK: single fill neck/ driver's
- FUEL TYPE: Diesel fuel only
- BED TYPE: Long bed Ford, Dodge, and GM
- NOTE: Add 1.5” to the width of the tank for the hold down tabs/Lock-Bar.
To connect this auxiliary fuel tank to your truck, please select either the "Push N Fuel" or the "Freedom Fill" auxiliary connection system. See details below to determine which system will work best for you. Please put the Year, Make, and Model of your truck in the notes section on the checkout page when completing the checkout process.“Freedom Fill” Auxiliary Tank System Explanation
When the system is turned on, the Freedom Fill Controller box will sense when the factory tank is approximately at a half a tank, the controller box will then turn the auxiliary in-line pump on, filling the factory tank to approximately three-quarters of a tank. The light on the switch will turn on allowing you to know when the system is transferring fuel. When the factory tank reaches approximately three-quarters of a tank, the pump will then turn off. When the auxiliary tank is empty, the system will not turn on. If the factory tank goes below approximate one-half of a tank, you know the auxiliary tank is empty. When the switch is in the off position, the auxiliary gauge and computer will be off, and will not transfer fuel from the auxiliary tank to the factory tank.
When the truck or the system first turns on, the pump &light will turn on for approximately 5 seconds, then turn off. If the factory tank needs fuel it will then turn back on and begin to transfer fuel. If the factory tank is above approximately ½ a tank, the system will remain off until the factory tank reaches the appropriate level of approximately ½ a tank. If the truck or Freedom Fill System is shut off during fuel transfer, it will not turn back on until the factory tank reaches approximately half a tank.
“Push N Fuel” Auxiliary Tank System Explanation
Whenever the truck ignition is on, you press and hold the momentary switch in the on position. With the switch depressed the inline fuel pump is activated and will begin to transfer fuel from the auxiliary tank to the factory tank. When you let go of the switch, the pump is turned off. The auxiliary gauge reads what is in the auxiliary tank. The factory gauge reads what is in the factory tank.
Do not press the momentary switch for more than 5 minutes, and allow ten minutes between reactivating the switch. This will allow the factory gauge to give a more accurate reading of the factory tank. Do not activate the momentary switch if the factory tank is above 3/4 of a tank. Failure to do so can result in over-filling/over-pressurization of the factory. Do not activate the momentary switch if the auxiliary tank is empty.
For more information on both of these auxiliary tank connection systems click HERE.